Operation Manual

User's manual SUNGOO Mobile Navigation 43.01
Working with the map - 35 -
Simulation: Simulates a navigation based on the displayed route. This
simulation can be performed without GPS reception. Simulation is,
however, restricted to routes of max 60 mi.
Store a Voice Command
: Prompts you to designate a voice command for the
selected destination so that you can start navigation to this destination
"on command".
For more detailed information, please refer to chapter "
Setting up a
voice command" on page
28.
Rename
: Opens a window in which you can change the name for the selected
destination or route.
Traffic
: Opens the TRAFFIC INFORMATION window in which pending reports are
listed. For detailed information, please refer to chapter "
TMC (Traffic
Information)" on page
44.
Show Turn-by-Turn List
: Shows detailed directions for the route, including all
points at which you must turn.
For more detailed information, please refer to chapter "
Turn-by-Turn
List" on page
43.
Factory Settings
: Opens a window in which you can reset all settings to the
original factory settings.
Delete Destination
: Deletes the highlighted destination from the list (LAST
DESTINATIONS or FAVOURITES). A dialog window prompts you to confirm
deletion.
Save Destination
: Saves the specified address in the FAVOURITES list.
For more detailed information, please refer to chapter "
Saving a
destination" on page
28.
Add to Route
: Opens route planning. The address specified will be added as the
first route point of a new route.
For more detailed information, please refer to chapter "
Routes with
stages" on page
29.
8 Working with the map
8.1 Maps
Even if you have stored several navigation maps on the navigation
system's memory card, SUNGOO Mobile Navigation can only operate
with one map at a time.
Tap on Options
> Settings > Current Map to see which map is currently
being used. You can also select another map here.