Operation Manual
Table Of Contents
- 1 Introduction
- 2 Before you begin
- 3 Operating the navigation software
- 4 Navigation
- 5 Managing Destinations
- 6 Routes with stages
- 7 Options
- 8 Working with the map
- 9 Useful functions
- 10 Configuring SUNGOO Mobile Navigation 35.01
- 11 Appendix
- 12 Index
User's manual SUNGOO Mobile Navigation 35.01
Before you begin - 9 -
The LED of the SUNGOO Mobile Navigation lights orange during
charging.
The LED lights green when the SUNGOO Mobile Navigation is fully
charged.
Note: It takes approx. 4-5 hours to charge the device when the battery
is flat.
A fully charged battery enables 4 hours of use.
2.3.2 Memory card
You will find the memory card containing the navigation software
inserted in the device.
Inserting a memory card
► Insert the memory card provided into the device (see image). Press
the card into the device until it locks into place.
Removing the memory card
Should it be necessary to remove the memory card from the device,
please proceed as follows:
1. Switch the navigation device off by pressing the
(On/Off/Standby
) switch for at least 6 seconds.
2. Press the memory card gently into the device until the lock
disengages.
2.3.3 Preparing the navigation system for use
Caution! Please be sure to refer to the safety information in chapter
"
Important safety information" on page 12.