Operation Manual

User's manual SUNGOO Mobile Navigation 35.01
- 18 - Navigation
Only your current position (triangle in orange) will now be shown on the
map.
4.1 Starting SUNGOO Mobile Navigation 35.01
1. Switch your navigation device on.
Each time the navigation device has been switched off completely
(by pressing the
(On/Off/Standby) switch for at least 6 seconds)
the following message appears when the software is started again:
"Please note that the road traffic regulations are prior to the
instructions of the navigation system. Please do not operate the
device while driving."
2. After you have read and fully understood the text, tap the OK
button.
3. If you do not accept these instructions, then tap the Cancel
button
in order to quit the navigation software.
The M
AIN WINDOW will open. You can reach all of the navigation
software functions via the M
AIN WINDOW.
4.1.1 Initialising the GPS-receiver
Note: It can take up to 20 minutes to initialise the integrated GPS
receiver for the first time.
Each time you switch on the receiver after this, the GPS reception will
start within one minute.
If the navigation device has been switched off for more than a week, the
next initialisation can take up to 10 minutes.
As soon as the navigation device has been switched on, initialisation of
the GPS-receiver will begin.
In the right-hand top corner of the display, you will see the GPS
symbol.
As soon as data from at least 3 satellites is received, the symbol
changes to
GPS Ready.
Note: If the GPS symbol displays GPS Ready after considerably less
than 20 minutes, it is advisable to leave the receiver switched on for at
least a further 15 minutes so as to ensure reliable operation.
Caution! If you have connected the navigation device to the power
supply via the vehicle's cigarette lighter, remove the connector before
you leave the vehicle standing for a longer period of time.
As the GPS receiver requires a constant supply of power, it could drain
the vehicle´s battery.