User Manual

80
In this experiment, it just needs to driv e one motor, so here only half of the L293D w ill be used.
DC Motor
This is a 5V DC motor. It will rotate when you giv e the two terminals of the copper sheet one
high and one low level. For convenience, you can weld the pins to it.
Size: 25*20*15MM Operation Voltage: 1-6V
Free-run current (3V): 70m A Free-run speed (3V): 13000RPM
Stall current (3V): 800mA Shaft diameter: 2mm
Power Supply Module
In this experiment, it needs large currents to drive the motor especially when it starts and
stops, which will severely interfere with the normal work of Raspberry Pi. Therefore, w e
separately supply power for the motor by this module to make it run safely and steadily.
You can just plug it in the breadboard to supply pow er. I t provides a v oltage of 3.3V and 5V,
and you can connect either via a jumper cap included.
SunFounder