User Manual

22
Introduction to Raspberry Pi
RAB Holder
RAB Holder is a basic but indispensable component for your experiment. I t makes your
experiment easier and can be used for fixing a bread board, an Arduino board like Uno
board or Mega2560, or a Raspberry Pi board.
Before starting the experiment, you need to fix the Raspberry Pi and the breadboard on the
RAB Holder first.
Remov e the sticker from the back of the breadboard first, and fix the breadboard on the
RAB Holder. Pay attention to place it in such a position as shown in the figure below, so that
the 3.3V pin and 5V pin on the T-Extension Board align w ith the bus strips besides the two red
lines when we insert the T-Extension Board later.
Then insert the T-Extension Board into the Breadboard, and insert the 40-pin GPI O Cable into
the board.
Red line
Blue line
SunFounder