Data Sheet

www.sunfounder.com
27
Circuit Connect
1) Connect the Sensor Shield into the copper standoff by M2.5 x 8mm screw.
2) Insert the three servos into the Sensor Shield, the numbers on the servos are as shown
below. Insert the 1 servo to the pin 2, 2 servo to pin 3, 3 servo to the pin 4, and IR receiver
module to pin 5.
Servo
Sensor Shield
IR Receiver
Sensor Shield
Orange
2,3,4
Black
5
Red
+
Red
+
Brown
-
Yellow
-
SunFounder