Manualshelf

Data Sheet

ManualsBrandsSunfounder ManualsMisc. Electronic Experimentation KitsSunFounder DIY Bionic Robot Lizard
11121314151617181920
www.sunfounder.com
10
Pay attention to the colors and the directions of the anti-reverse cable.
Upload the code
4) If everything looks good, connect the Sensor Shield to your PC with a USB cable, then the blue
LED on SunFounder Nano board will light up.
If there display “USB Device not recognized”, it means that you haven’t installed the driver, thus you
need to install the driver below:
For Windows users, run
PL2303_Prolific_DriverInstaller_v1180B
in the folder Driver.
For Mac users, refer to the folder
PL2303_MacOSX_1_6_1_20170620
in the folder Driver.
5) Open the Arduino Software (IDE), Select File->Open. On the pop-up window, go to the Bionic
Robot Kit for Arduino – Lizard -> Code -> Test directory and find
Test.ino
. Click it to open.
SunFounder