Data Sheet

www.sunfounder.com
9
Test
Build Circuit
1) Insert SunFounder Nano board into the Sensor Shield. Note: The USB port should be at the
same side with blue power supply terminal.
2) Insert the battery JST female pin into the red power of the Sensor Shield.
3) Connect 3 servos and Infrared receive module with sensor shield. Insert 3 rocker arms into
servos in that observe if they are rotate or not.
Note: The Black wire of IR Receiver module connect to sensor shield pin 5, then yellow wire
connect to GND pin
Servo
Sensor Shield
IR Receiver
Sensor Shield
Orange
2,3,4
Black
5
Red
+
Red
+
Brown
-
Yellow
GND
SunFounder