User Manual

43
Calibration: Camera
When completed, the camera should look like the figure above. The camera should be in
the center line of the car and face exactly front. You can use the keyboard to adjust, by the
arrow keys ↑, ←, ↓, and →, or W, A, S, and D. The servo turning angle is very small, so it's quite
suitable for fine tuning; press and hold it to coarsely adjust quickly. Click OK or press Alt + O
to save the calibration result; click Cancel or press Alt + C to cancel the calibration and exit.
Notes:
During the calibration, the servo may get stuck with an abnormal sound, and heated
abnormally after a while if the servo shaft is not adjusted to 90° in the previous
mechanical assembly. You should at once disconnect the wires of the servo and remove
the rocker arm to readjust the shaft to 90° (refer to the previous Servo Configuration part).
After all the adjustments are done, click OK, and the server will write the data into the
database files. Then the servo will respond to the database initialization with a little
movement. Only after the initialization is done can you start the next step, or the server will
reject the calibration request.