User Manual

34
Make sure the servo shaft has spun to 90 degrees. Then assemble the Tilt Arm and The Gasket
with the Rocker Arm Fixing Screw in a fixed angle as shown below:
Note: Do not rotate the servo by hands in case of breaking the servo down.
Similarly check that the servo shaft has spun to 90 degrees. Then assemble the Pan-and-tilt
Base with the Rocker Arm Fixing Screw and The Gasket in the angle as shown below (the
shaft of the pan servo should be closer to the left of the base plate):
Assemble the Pan-and-tilt to the car with two M3x10 screws and the M3 nuts if everything is
OK.
Note: In order to see clear the process of assembling, the servo in the picture is not in 90
degree. Do not rotate the servo grudgingly in case of breaking the servo down.
Camera Mount