User Manual

29
Mount the servo that connects to PWM Channel 0, the steering servo, to the Upper Plate
with two M2x8 Screws and M2 nuts (pay attention to the direction of the servo wires):
Connect the Steering Linkage and the rocker arm. Make sure the rocker arm is in an angle
as shown below. Try to spin the arm on the shaft, NOT on the linkage). If it's unmovable, it
means the servo is adjusted to 90 degrees. But if it spins, it indicates that the servo is not
adjusted successfully; check whether the wiring is correct and run the program at Step 5
before. Besides, the screw is quite sharp at the end, so be careful to assemble in case of
getting hurt.
If everything is OK, take out the Rocker Arm Fixing Screw (the shortest) to connect them as
shown below.