User Manual

23
immediately, but all servos will keep at 90 degrees. You can continue the rest assembly.
Warning: After power is on, a short circuit may happen because the exposed contacts of the
PCB may be touched by conductive objects like screw or screwdriver. If it occurs, please
remove the conductor immediately or unplug the power as quickly as you can.s
Build the Rest of the Car
Connect the Steering Linkage and the rocker arm. Make sure the rocker arm is in an angle as
shown below. If there is just a littile deviation from the right position of the rocker arm, it can
be fine tuned by software. Try to spin the arm on the shaft. If it's unmovable, it means the servo
is adjusted to 90 degrees. But if it spins, check whether the wiring is correct. Besides, the screw
is quite sharp at the end, so be careful to assemble in case of getting hurt.
If everything is OK, take out the Rocker Arm Fixing Screw to connect them as shown below.
Take out the assembled front wheels and the Upper Plate, and mount the wheels onto the
Upper Plate carefully: insert one bulge of the Steering Connector at either wheel into the hole
on the Steering Linkage plate, and another bulge into the Upper Plate, and similar with the
other wheel.