User Manual

17
And also fasten them as tightly as possible, and then loosen the screw a little so the Steering
Linkage can move flexibly.
Mount the steering servo to the Upper Plate with two M2x8 Screws and two M2 nuts (pay
attention to the direction of the servo wires):
Till here the car assembly is mostly done. But don’t hurry to assemble the front wheels, because
the servo has not been adjusted yet. An unadjusted servo may get stuck and further get hot
and burnt when it is connected to power to use as it is. To adjust, you can use your own way,
like uploading an Arduino program to the servo which makes it rotate to the 90 degrees and
stop, or using the servo adjustment code provided in this kit.