User Manual

22
3
．
Click this combined block and say "turn on" to the PiSmart. Wow, the LEDs on the PiSmart
just light up!
To understand: When the PiSmart receives the command for the words "turn on", block
above will return true and the program will run the brightness setting in
block ; If no command is received, nothing will happen. Therefore, after
the LEDs light up, you need to click the led off block to turn them off.
4
．
Click the combined block again and the program will stop running.
5
．
Drag other two if blocks , so after the PiSmart "hears" "off", LEDs will be turned off. so after
the PiSmart "hears" "twinkle", LEDs will flashing 10 times.
Click the chunk block again. This time try to say "turn on" or "turn off" or "light flashing" to the
SunFounder