Manual

38
Thigh + Crus
1. Connect the servo rocker arm of thighs and the servo of crura with servo screws.
(Packaged with the servo, the servo screws are within the smaller two of five screws.)
The directions of all components must be exactly the same with the following picture:
2. Tighten the screws.
3. After connection, the front view is as follows. Please pay attention to the direction of
these components, it should be vertical. Try your best to make it close to the following
picture, but if there is some deviation, that’s OK.
Switch off the SunFounder Servo Control Board. Remove the batteries first, then the battery
holder, and finally all the servo wires. NOW you can rotate any joints of the robot.
SunFounder