Manual

21
7. Connect the SunFounder Mobile Robot Remote Controller to PC with a USB cable. If
everything looks good, switch it on. Then the blue LED on SunFounder Nano board will
light up.
8. Upload the Transmit.ino under Quadruped Crawling Robot Kit V2.0 for
Arduino\code\2.nrf24l01\Transmit directory for the SunFounder Mobile Robot Remote
Controller according to the method in the previous section. Then Remove the USB cable
after upload, and keep the power on.
9. Connect the SunFounder Servo Control Board to your PC with a USB cable.
10. Upload the Receive.ino under the Quadruped Crawling Robot Kit V2.0 for
Arduino\code\2.nrf24l01\Receive directory for the SunFounder Servo Control Board
according to the method in the previous section:
Do not remove the USB cable after upload. Open Serial Monitor.
Now, you should see information received by the nFR24l01 module displayed on the Serial
Monitor window. Turn the rocker arm. The value displayed on the Serial Monitor window
will change, which indicate wireless communication is working.
Remove the USB cable and turn off the power switch.
SunFounder