Manual

15
name of the pins and the color of the wires are marked on two sides of all the pins.
Connect to the red wire of the battery holder to “+” of the power switch, the black wire
to the “-”. Pay attention not to connect them inversely; otherwise it may cause a short
circuit and burn the board.
3) If everything looks good, connect the SunFounder Servo Control Board to your PC with a
USB cable, then the blue LED on SunFounder Nano board will light up.
Do not mount the
battery inversely.
“+” and “-” are
marked inside the
battery holder.
Power Switch
Servo
Brown to GND
Red to VCC
Orange to Signal
SunFounder