Manualshelf

User Manual

ManualsBrandsSunfounder ManualsHumanoid and Biped Robots4-DOF Biped Learning Kit for Arduino Nano
21222324252627282930
28
Put an M3 nuts into the slot of the ultrasonic fixing plate, insert an M3*8 screw into the battery
fixing plate and fasten them.
vii. Servo CALIBRATION Test
Open the program and go to Line 39, disable the INSTALL and activate the CALIBRATION.
Select the correct board and port, then upload the sketch. If the robot is not set right, change
the angle and upload the code until it is.