User Manual

Put the servo control board onto the M3*6+6 Single-pass aluminum standoffs (on the other

opposite side of battery holder), align the holes of them and fasten with M3*6 screws.

Then fix the wires of battery holder to the power supply terminal. Note: Make sure the servo

control board direction is shown as below:

iii. Servo Assembly

Put the servo into the slot of the servo fixing plate and hold it. Then insert the M2*8 screws

from underneath the hole and fasten with an M2 nuts. Fasten the other screw, assemble the

other servo in the same way. Pay attention the shaft of the two servos should be toward the

same direction.