Owner Manual
3
Connect the wire from the solar panel into the socket located
under the light xture. Your solar motion light will now begin to
charge.
Prior to using your solar motion light, the solar panel needs to
be connected to the light for a period of three days. This initial
charge should be done in the OFF position. After the third day,
your included batteries will be fully charged and your solar motion
light is ready for operation. Place the light in the AUTO position.
The ON position acts to override the motion activation function.
This will allow a limited period of constant illumination.
ON | OFF | AUTO
ON | OFF | AUTO
ON | OFF | AUTO
7
9
6
8
Two different control switches adjust the light’s illumination time
and range of motion detection.
TIME: Determines the duration of the light once motion is
detected: 30 seconds, 60 seconds or 120 seconds.
• Test: Allows the positioning of the light’s motion sensor
to be tested day or night. Once the motion sensor is in the
desired position, attempt to trigger the light by moving
in the intended detection zone. If the light illuminates, the
motion sensor is positioned correctly. You are now ready
to move the switch to the preferred duration option. The
light will now only turn on in darkness.
DISTANCE: Controls the distance of the range of motion
detection: low, medium or high.
Batteries are located in the battery housing behind the light
xture. Select the OFF position on the light prior to opening the
battery housing. Remove the four screws to reveal the batteries.
When replacing the batteries, observe the correct polarity and
match the battery specications with the batteries you have
removed. Use rechargeable batteries only.