Owner Manual
3
Connect the wire from the solar panel into the socket
located under the light xture. Your solar motion light will
now begin to charge.
Prior to using your solar motion light, the solar panel
needs to be connected to the light for a period of three
days. This initial charge should be done in the OFF
position. After the third day, your included batteries will
be fully charged and your solar motion light is ready for
operation. Place the light in the AUTO position.
The ON position acts to override the motion activation
function. This will allow a limited period of constant
illumination.
Two different control switches adjust the light’s illumination
time and range of motion detection.
TIME: Determines the duration of the light once motion is
detected: 30 seconds, 60 seconds or 120 seconds.
• Test: Allows the positioning of the light’s motion sensor
to be tested day or night. Once the motion sensor is in the
desired position, attempt to trigger the light by moving
in the intended detection zone. If the light illuminates, the
motion sensor is positioned correctly. You are now ready
to move the switch to the preferred duration option. The
light will now only turn on in darkness.
DISTANCE: Controls the distance of the range of motion
detection: low, medium or high.
6
8
5
7
Once the motion light is installed, the lamp heads
can be adjusted independently in a variety of ways
for optimal lighting coverage.
Batteries are located in the battery housing behind the light
xture. Select the OFF position on the light prior to opening
the battery housing. Remove the two screws to reveal the
batteries.
When replacing the batteries, observe the correct polarity
and match the battery specications with the batteries you
have removed. Use rechargeable batteries only.