Owner Manual

Connect the wire from the solar panel into the socket

located under the light xture. Your solar motion light will

now begin to charge.

Once the motion light is installed, the side lamp

heads can be adjusted independently in a variety of

ways for optimal lighting coverage.

This screw can be tightened to secure

the positioning of the side lamp heads.

Do not over-torque this screw as this

action can damage the plastic joint.

Prior to using your solar motion light, the solar panel

needs to be connected to the light for a period of three

days. This initial charge should be done in the OFF

position. After the third day, your included batteries will

be fully charged and your solar motion light is ready for

operation. Place the light in the AUTO position.

The ON position acts to override the motion activation

function. This will allow a limited period of constant

illumination.

ON | OFF | AUTO

Batteries are located in the battery housing behind the

light xture. Select the OFF position on the light prior to

opening the battery housing. Remove the four screws to

reveal the batteries.

When replacing the batteries, observe the correct polarity

and match the battery specications with the batteries

you have removed. Use rechargeable batteries only.

Two different control switches adjust the light’s illumination

time and range of motion detection.

TIME: Determines the duration of the light once motion is

detected: 30 seconds, 60 seconds or 120 seconds.

• Test: Allows the positioning of the light’s motion sensor

to be tested day or night. Once the motion sensor is in the

desired position, attempt to trigger the light by moving

in the intended detection zone. If the light illuminates, the

motion sensor is positioned correctly. You are now ready

to move the switch to the preferred duration option. The

light will now only turn on in darkness.

DISTANCE: Controls the distance of the range of motion

detection: low, medium or high.