Use and Care Manual

Connect charge controller to battery
First, disconnect solar panels and connect charge controller to battery. Always connect
charge controller to battery first and remove last. Observe polarity – positive to positive and
negative to negative.
Reconnect Solar Panels to Charge Controller
If battery voltage is 14.2 or higher, the GREEN light should be on. If battery voltage is
between 13 and 14.2, the YELLOW LED should be on. If battery voltage is 13 or lower, the
YELLOW LED should be on.
If all testing results within the above indicated ranges, solar system is in acceptable range.
If Voltage readings indicate lower ranges, repeat above connections and retest. Finally, it is
common to have 12V Battery issues such as dead cells or non-rechargeable battery
problems.
Warranty
The 12 Volt Solar Battery Charger is covered by a five year limited warranty. Sunforce Products
Inc warrants to the original purchaser that this product is free from defects in materials and
workmanship for a period of one year from date of purchase. Power output is warranted for five
years from date of purchase.
The 7 Amp Solar Charge Controller is covered by a five year limited warranty. Sunforce Products
Inc warrants to the original purchaser that this product is free from defects in materials and
workmanship for a period of one year from date of purchase.
To obtain warranty service please contact Sunforce Products for further instruction, at
1-888-478-6435 or email [e-mail]. Proof of purchase including date, and an
explanation of complaint is required for warranty service.
For more information or technical support
Pour plus d’information ou support technique
1-888-478-6435
www.sunforceproducts.com
[e-mail]
Made in China
Fabriqué en Chine