- Bob Carver's Sunfire True Subwoofer Signature and Standard Version User's Manual

User's Manual
19
SpeciÞ cations (Signature Edition)
AmpliÞ er Output
2,700 watts rms (3.3 impedance)
High Cut Filter
30 Hz - 100 Hz adjustable, with a
"Bypass" position.
Frequency Response
16 Hz - 100 Hz
Power Line Voltage
US model
120 VAC 50/60 Hz
International model
230 VAC 50/60 Hz
Dimensions
13" x 13" x 13"
Weight
53 lbs
Finish
High gloss, dark rosewood Þ nish.
Line Power Consumption:
800 watts average, at maximum continu-
ous output. 8 watts at idle.
2,700 watts peak, time limited basis
Output Levels:
Greater than 116 dB peak SPL (includes
room gain) from 16 Hz to 100 Hz. Mea-
surement is one meter, anechoic.
A typical SunÞ re subwoofer can be
ex pect ed to ‘best’ its spec i Þ ed minimum
peak SPL by several decibels.
Total Harmonic Distortion
Typically less than 1/10 of the fun da -
men tal between 18 to 80 Hz.
Input Sensitivity for full
output:
250 mVrms from left input with volume
control at 0 dB, 60 mVrms volume con-
trol fully clockwise
*
0.75 Vrms from right input with volume
control at 0 dB, 200 mVrms volume
control fully clockwise
*
Input Impedance:
30 k for Line-Level inputs
56 k for Hi-Level inputs
40 k for XLR input, each leg balanced
to ground
XLR Input
Pin 1 Ground
Pin 2 Positive
Pin 3 Negative
Driver: 12 inch
Extra large magnet and long throw
me chan i cal design yield very high
back-emf. The result is ex traor di nar i ly
high operating efÞ ciency – that is, more
acoustic output for each watt of input.
Internal System Gain:
50 dB from left input jack to speaker
with volume control at 0 dB, 62 dB with
control fully clockwise
*
40 dB from right input jack to speaker
with volume control at 0 dB, 52 dB with
control fully clockwise
*
*
The SunÞ re True Sub woof er utilizes
differential gain on the left and right
inputs to retain both L+R and L-R
information.
12 VDC Trigger Input
Input voltage range: 5 -18 VDC
Impedance: approx 600
(20 mA @ 12 V)
Removable terminal block, and one 1/8”
Mono minijack, tip positive.