Product Manual

5207 2 Rev. 06/23/03
USING THE 5207
ENGINE TRANSVERSE BAR…
First, determine the location of the two engine support bolts
to which the 5207 Engine Support Bar will be attached.
Then, place the Engine Support Bar directly over these two
engine support bolts, making sure that the feet with
protective sleeves (#13,14) are sitting in the inner fender
lips of the engine compartment and fully extended until the
feet are touching the inside of the fenders.
CAUTION: If the inside fender lips are more than 61"
apart, the 5207 Engine Transverse Bar must not be used.
Do not extend past the designated marking (61") as
over-extending this unit may compromise the 700 lb.
Capacity. This could cause the Engine Support Bar to
collapse, resulting in bodily injury or property damage.
Next, make sure the transfer bar is in correct position (if
being used). The rubber tip of the adjustable pipe (#6)
should be on a flat, reinforced surface capable of
supporting the weight of the engine. Tighten both wing
nuts (#4, 8) to secure adjustable pipe (#6) and transfer
bar (#10).
Now, the J-hooks (#3) may be lowered to the appropriate
position. Be sure J-hooks are directly over the engine
support bolts or brackets so the engine does not swing
when vehicle is disassembled. Attach the looped ends of
the two 1/8" braided steel cables (#12) to the engine
support bolts on the engine and loop middle of braided
cables over J-hooks. If the engine being supported is
equipped with engine lift brackets, hook the J-hooks
directly into engine lift brackets for extra protection.
NOTE: Use only fasteners rated Grade 5 or higher as
engine support bolts.
Tighten the barrel hex nuts (#7) on both J-hooks until
cables are snug or hex nuts are tight against support bar.
Double check that engine is properly supported before
disassembly of vehicle.
LIMITED WARRANTY…
SUNEX INTERNATIONAL, INC. WARRANTS TO ITS CUSTOMERS THAT THE COMPANY’S SUNEX TOOLS
®
BRANDED PRODUCTS ARE FREE FROM DEFECTS IN WORKMANSHIP AND MATERIALS.
Sunex International, Inc. will repair or replace its Sunex Tools
®
branded products which fail to give satisfactory service due to
defective workmanship or materials, based upon the terms and conditions of the following described warranty plans attributed
to that specific product. This product carries a ONE-YEAR warranty. During this warranty period, Sunex Tools will repair or
replace at our option any part or unit which proves to be defective in material or workmanship.
Other important warranty information...
This warranty does not cover damage to equipment or tools arising from alteration, abuse, misuse, damage and does not cover
any repairs or replacement made by anyone other than Sunex Tools or its authorized warranty service centers.The foregoing
obligation is Sunex Tools’ sole liability under this or any implied warranty and under no circumstances shall we be liable for any
incidental or consequential damages.
Note: Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or
exclusion may not apply to you. Return equipment or parts to Sunex Tools, or an authorized warranty service center,
transportation prepaid. Be certain to include your name and address, evidence of the purchase date, and description of the
suspected defect.
If you have any questions about warranty service, please write to Sunex Tools. This warranty gives you specific legal rights and
you may also have other rights which vary from state to state. Repair kits and replacement parts are available for many of Sunex
Tools products regardless of whether or not the product is still covered by a warranty plan.
Shipping Address: Sunex Tools • 315 Hawkins Rd. • Travelers Rest, SC 29690
Mailing Address: Sunex Tools • P.O. Box 4215 • Greenville, SC 29608