SunDanzer Batter y-Powered Refrigerator & Freezer User’s Guide SunDanzer 11060 Dyer D-12 El Paso, TX 79934 820 41 82 80 Rev.
INTRODUCTION Congratulations! You have purchased one of the most efficient refrigeration products available on the market today. The SunDanzerTM chest freezers and chest refrigerators are designed to provide years of efficient trouble-free operation. The design is optimized for energy savings with an efficient DC compressor, thick insulation, and a chest style configuration.
IMPORTANT SAFETY INSTRUCTIONS These warnings are provided in the interests of your safety. Please ensure that you understand them all before installing or using this appliance. Your safety is of paramount importance. If you are unsure about any of these meanings or warnings, contact SunDanzer or your local product dealer for assistance. Prior to Installation At the delivery, please check that the appliance is complete and has not been damaged during transport.
At the end of the appliance life When disposing of your appliance, use an authorized disposal site. The refrigerant must be completely drained and collected by an authorized technician for recycling prior to disposal. Check with your local Environmental Agency for recommendations on recycling this appliance in your area. Remove the electrical connection wiring and also ensure that the lid is removed to prevent young children from being trapped inside.
Electronics Diagram or 7.5A fuse Fuse A fuse is required in order to protect the wiring. A standard automobile fuse is recommended and the fuse should be wired to the positive (“+”) side of the system close to the positive battery terminal. For 12V operation, use a 15A fuse, and for 24Voperation use a 7.5A fuse. Operating Voltage Fuse 12V 15A 24V 7.
Starting the Appliance After the appliance has been properly connected to the 12 or 24 VDC power source, the compressor will automatically turn on and the cabinet will begin cooling. Allow the cabinet to cool for at least 4 hours prior to adding foodstuff. Temperature Control The temperature within the appliance is controlled by the thermostat situated on the lower front of the cabinet.
Baskets The baskets are designed for the storage and organization of food. The handles can be placed in two positions, as shown. The baskets can either be placed or stacked inside the cabinet, or hung on the edge of the inner casing. To change the configuration from stackable baskets to hanging baskets, turn the plastic pieces outward and lock into place. To change the configuration from hanging baskets to stackable baskets, simply reverse the procedure.
External Cleaning Wash the outside of the cabinet with warm water and a mild soap or detergent. Do not use abrasive or corrosive cleaning agents, chemical cleaning agents, steel wool or scouring sponges to complete this task as it may cause damage to the surfaces. TO CHANGE THE LIGHT BULB 1. Disconnect the appliance from the electrical power supply. 2. Remove the plastic cover. 3. Unscrew the bulb. 4. Replace with a new bulb (max 15 Watt) 5. Reconnect to the electrical power supply. 6.
