Owner Manual

Care and Maintenance
16
16
Gas odour with extreme yellow tipping of flame.
Visually check portions of the hose assembly located within the confines of the heater post. Inspect the entire
hose assembly at least annually, disassembling the reflector and burner. Inspect the hose assembly for evidence
of excessive abrasion, cuts, or wear. Suspected areas should be leak tested. Then assembling the reflector and
burner again following with step 6 and 7.
Heater does NOT reach the desired temperature.
Heater glow is excessively uneven.
Heater makes popping noises.
Spiders and insects can nest in burners or orifices. This dangerous condition can damage the heater and render it
unsafe for use. Clean burner holes by using a heavy-duty pipe cleaner. Compressed air may help clear away smaller
particles.
Carbon deposits may create a fire hazard. Clean dome and burner screen with warm soapy water if any carbon
deposits develop.
Note: In a salt-air environment (such as near an ocean), corrosion occurs more quickly than normal.
Frequently check for corroded areas and repair them promptly.
TIP:
Use high-quality automobile wax to help maintain the appearance of
your heater. Apply to exterior surfaces from the pole down. Do not
apply to emitter screen or domes.
Storage
Between uses:
Turn control knob OFF.
Disconnect LP source.
Store heater upright in an area sheltered from direct contact with inclement weather (such as rain, sleet, hail,
snow, dust and debris).
If desired, cover heater to protect exterior surfaces and to help prevent build-up in air passages.
Note: Wait until heater is cool before covering.
During periods of extended inactivity or when transporting:
Turn control knob OFF.
Disconnect LP source and move to a secure, well-ventilated location outdoors.
Store heater upright in an area sheltered from direct contact with inclement weather (such as rain, sleet, hail,
snow, dust and debris).
If desired, cover heater to protect exterior surfaces and to help prevent build-up in air passages.
Never leave LP cylinder exposed to direct sunlight or excessive heat.
Note: Wait until heater is cool before covering.
Service
Only a qualified service person should repair gas passages and associated components.
Caution: Always allow heater to cool before attempting service.
SKU:F18B411 & F18G412 & F18S413