Owner Manual

14
Operation Checklist
Shut Down:
Turn cylinder valve clockwise to OFF and disconnect regulator when heater is not in use.
Note:
After use, some discolouration of the emitter screen is normal.
For a safe and pleasurable heating experience, perform this check before each use.
When Heater is ON:
Emitter screen will become bright red due to intense heat. The colour is more visible at night. Burner will display tongues
of blue and yellow flame. These flames should not be yellow or produce thick black smoke, indicating an obstruction of
airflow through the burners. The flame should be blue with straight yellow tops. If excessive yellow flame is detected,
turn off heater and consult “Troubleshooting” on page 16.
Re-lighting:
1. Turn control knob to OFF.
2. Repeat the “Lighting” steps on previous page.
WARNING
FOR YOUR SAFETY
Heater will be hot after use. Handle with extreme care.
Before Operating:
1. I am familiar with entire owner’s manual and understand all precautions noted.
2. All components are properly assembled, intact and operable.
3. No alterations have been made.
4. All gas connections are secure and do not leak.
5. Wind velocity is below 10 mph.
6. Unit will operate at reduced efficiency below 40°F.
7. Heater is outdoors (outside any enclosure).
8. There is adequate fresh air ventilation.
WARNING
FOR YOUR SAFETY
Be careful when attempting to manually ignite this
heater. Holding in the control knob for more than 10
seconds before igniting the gas will cause a ball of
flame upon ignition.
Operation Instructions
14
SKU:F18B411 & F18G412 & F18S413