User's Manual
Using your answering machine (Telstra 5200a only)
29
Note
Throughout the
recording process, r
will flash on the base
unit display
To record your own Answer and Record outgoing message
You can record your own Answer and Record outgoing message to use
instead of the pre-recorded message already available.
Your outgoing message can be up to 3 minutes long. Your own outgoing
message will replace the Answer and Record pre-recorded outgoing
message, but it is possible to reinstate it later if you wish (see page 31).
1. Press and hold the
button.
You will hear the following announcement, “Please select outgoing
message”.
2. To record your own Answer and Record outgoing message, press
button.
The prompt will announce, “Hello, your call cannot be taken at the
moment, so please leave your message after the tone.” To record a new
outgoing message, press and hold the skip back button”.
3. Press and hold the
button.
The prompt will announce, “Please speak after the tone. To end recording,
release the button”.
4. Record your outgoing message by speaking into the base unit (approx.
40 cm). When finished, release the
button.
You new outgoing message will be played back to you.
Using the phone
22
Factory Settings
Language: English
Battery warning tone: On
Range warning: On
Button click: On
Receiver volume: 3
PIN code: 0000
Pause: 3 sec.
Handset name: EDGE
Auto Answer On
External ring tone: 2
Internal ring tone: 5
Handset ring tone volume: 3
Base ring tone: 2
Base ring tone volume: 3
Flash time: 100ms
5200-5200a.indd, Spread 23 of 26 - Pages (30, 23) 20/9/05 12:32 PM