User's Manual

Using the phone
21
*Monthly charges
apply. Service
available in most
areas. Not available
for blocked calls.
When the alarm
sounds, press either
lift the handset off
the base or press any
key on the handset.
IMPORTANT
Please note that
if you reset your
Telstra 5200/5200a
the Phonebook,
Redial and Calls list
will be deleted.
Time settings
Set time
If you have subscribed to Telstra Calling Number Display feature*, the
time will be set automatically when you receive your first call. You can
also set the time manually.
1. Press
scroll to handset.
2. Press the
button to confirm.
3. Scroll
to CLOCK SET and press the button to confirm.
4. Enter the current time in 24 hour format using the keypad. E.g. 2.04PM
= 1404.
5.Press the
button to confirm.
Set alarm
1. Press the
button.
2. Scroll to HANDSET and press the button to confirm.
3. Scroll
to ALARM SET. Press to confirm.
4. The display will show OFF. Press
to change to ON, then press .
5. The display will show 0-00. Enter the required wake up time in 24 hour
format using the keypad. Press the button to confirm.
To default/reset the handset & base to original settings
1. Press the
button and scroll to SETUP.
2. Press the
button to confirm.
3. Scroll
to DEFAULT and press the button to confirm.
4. Using the keypad enter your PIN and then press the
button to
confirm.
5. The message CONFIRM? will appear in the display. Press the
button to confirm.
Using your answering machine (Telstra 5200a only)
30
Note
When recording your
own Answer Only
outgoing message,
please remember not
to invite your caller
to leave a message,
as the Answer Only
mode will not record
incoming messages.
Note
On the base unit
press the
button
at any time during
playback to stop
messages playing.
To record you own Answer Only outgoing message
You can record your own Answer Only outgoing message to use instead
of the pre-recorded message already available. Your outgoing message
can be up to a maximum recording capacity (11 minutes), but you should
try to keep it short to allow time for recording memos, or incoming
messages when using the alternative Answer and Record outgoing
message. Your own outgoing message will replace the Answer Only pre-
recorded outgoing message, but it is possible to reinstate it later if you
wish (see page 31).
1. Press and hold the
button.
You will hear the following announcement, “Please select outgoing
message”.
2. To record your own Answer Only outgoing message, press
button.
The prompt will announce, “Hello, your call cannot be taken at the
moment and you cannot leave a message, so please call later.
To record a new outgoing message, press and hold the
button.”
3. Press and hold the
button.
The prompt will announce, “Please speak after the tone. To end recording,
release the button”.
4. Record your outgoing message by speaking into the base unit (approx.
40 cm). When finished, release the
button.
You new outgoing message will be played back to you.
To check or play your outgoing message
You can check and play back your current outgoing message at any time
via your base unit.
Press the
button.
The prompt will announce either:
”Answer on, your outgoing message is …..” and play your currently selected
outgoing message.
Or
”Answer off”. If prompt is “Answer off”, press the
button again and
the prompt will announce the current outgoing message.
5200-5200a.indd, Spread 22 of 26 - Pages (22, 31) 20/9/05 12:32 PM