User's Manual
7471
–
hilips
DE
B)
–
1
14.06.06
CT
522
–
3111-285-31161-
522-UG
_
3111-285-31161-
(
GB
)
.indd 2 14/6/06 17:02:
0
FCC Interference Information
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference; and (2) This device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna (that is, the antenna for radio
or television that is “receiving” the interference).
• Reorient or relocate and increase the separation between the
telecommunications equipment and receiving antenna.
• Connect the telecommunications equipment into an outlet on a circuit
different from that to which the receiving antenna is connected
FCC RF Radiation Exposure Statement
The installation of the base unit should allow at least 20 centimeter
between the base and persons to be in compliance with FCC RF exposure
guidelines. For body worn operation, the portable part (handset) has been
tested and meets FCC RF exposure guidelines.
This device must not be co-located or operating in conjunction with any
other antenna or transmitter. The changes or modifications not expressly
approved by the party responsible for compliance could void the user’s
authority to operate the equipment.