User's Manual
Table Of Contents
- Features of SunCorp GAP DECT
- Main User interface
- Call User interface
- MENU Settings
- Prefix dialling
- DECT 24 addendum (Set the EEPROM setting for DECT 24)
- Quick default settings
- Subscribe a new handset
- Test modes
- Specifications
4.3.10 KEY LOCK
This function allows you to lock the key
• Select "Key lock ?” and validate
• Press KEY_MENU/OK to lock key,
icon displayed and go to standby mode.
Note: Press KEY_HOOK key can be OFF HOOK during incoming call and Key Lock is on.
4.3.10.1 Quick KEY LOCK
Simply press and hold KEY_STAR/LOCK 3 second
4.3.10.2 To unlock key:
• Press any key “Press *” is displayed, within 5s time out
• Press KEY_STAR/LOCK to unlock key
4.4 REGISTER
• Select "Register" and validate
• Select “Select Base” or “Reg Base” by KEY_UP or KEY_DOWN
• Press KEY_OK to confirm
4.4.1 SELECT BASE
• Select "Select Base" and validate
• “Base 1 2 3 4” is displayed (only the registered base number will be shown and current base
number will be blinking)
• Press 1 - 4 to confirm the selection or KEY_UP/KEY_DOWN + KEY_F to select auto
searching.
• Valid tone is sounded if valid base is found
• “Not Register” is shown and error tone sounded the selection is invalid
4.4.2 REG BASE
• Select "Reg Base" and validate
• “Base 1 2 3 4” is displayed (only the registered base number will be blinking )
• Press 1 - 4 to confirm the selection
• It is now searching the base in subscription mode and “Searching…” is displayed
• Valid tone is sounded and “PIN ?” is shown if valid base found
• Enter subscription PIN code and verified by base
• Valid tone sounded if subscription is successful and back to standby mode.
On the base:
• Put the base into subscription mode, by pressing and holding PAGE_KEY
• The base will then emit a beep, the Line LED will flash. It is now ready to be associated with a
new handset, during the 90 seconds after pressing the button only.
If the handset has located the base, a valid tone is played.
If the handset does not locate the base, it will return to the previous configuration after 1 minute. Try
again by changing the base number and check that you are not in a environment where there is
interference
When a handset is associated with a base, it is given a handset number by the base. It is this number
which is displayed on the handset after the name and must be used for internal calls.
35 of 40