User's Manual

4.2.4 PIN CODE
The base PIN code is used in subscription operation or to modify some critical parameters in the base.
To change the PIN code:
• Select "PIN code" and validate
• Enter the old 4 figure confidential code and validate
• Enter the new 4 figure confidential code and validate
• Enter the new confidential code a second time and validate
4.2.5 Dial mode selection (This mode will not appear when set the Pulse dialling disable by
EEPROM)
Two types of dialling are available:
1. DTMF tone dialling
2. Pulse dialling
To change the dialling mode:
• Select “Dial Mode” and validate
• Select “Tone” or “Pulse” of dial mode and validate
FTXX_DIAL_MODI : selected by EEPROM data
Note: the Dial mode selection menu can be hidden to lock the base into pulse or DTMF dialling by the
CONFIG_ENA_MENU_DIALMODE flag (see various factory settings).
4.2.6 Recall duration selection
• Select "Recall"
• Choose Recall 1 to select short flash time
• Choose Recall 2 to select long flash time
RECALL 1 & 2 timing: selected by EEPROM data
Note: not recall select function in if Recall 1 & Recall 2 is same timing.
4.2.7 Default settings
This menu enables you to reset both handset and base with default settings.
• Select "Default"
• Enter the base PIN code and validate
• "Confirm ?" appears, press KEY_OK to confirm
Then the handset and base will apply default parameter settings and make a software RESET.
Default parameter Value
Handset name To be advised
Low battery indicator ON
Out of range indicator ON
Key click ON
Auto answer ON
INT melody 1
INT volume 3
EXT melody 1
EXT volume 3
Ear volume 3
Language English
Phonebook Empty
CLID list Empty
Redial list Empty
PIN CODE 0000
PAUSE 3 s
Dial mode DTMF
32 of 40