User's Manual

Table Of Contents

3.12 Range indication

3.12.1 Out of range tone

If the following conditions are applied:

• The handset has been out of range since EEP_RANGE_OUT_DELAY s

• If range warning tone option is ON

then a TONE_WARNING will be played.

EEP_RANGE_OUT_DELAY : selected by EEPROM data

3.12.2 In range tone

If a TONE_WARNING has been played, a TONE_IN_RANGE is played when the handset goes into

range the next time.

Note: at start-up, the handset plays the TONE_IN_RANGE only if it goes into range after more than 10

3.12.3 Range limit tone during a call

During a call, in range limit conditions, the handset will play a TONE_WARNING in the Buzzer

The tone is repeated until range conditions are good

If the handset goes out of range, the call is released (on both handset and base).

3.13 Clock and Alarm clock

3.13.1 Clock

The handset has clock indication. The clock data is inside the base unit. So, all the handsets have

same clock indication.

• Update the time by using one of handset.

• The time data is also updated by CLIP data if the CLIP data has time data.

3.14 Alarm activation

When the unit is set to alarm ON and the clock reach to the alarm setting time, the handset shall

generate the alarm sound. And Alarm icon

needs to be turned ON on the LCD. Once the clock is

reach to alarm setting time, start to generate the alarm sound. When stop generating alarm sound, the

alarm setting shall be OFF and the icon

shall be turned OFF.

3.14.1 During idle

The sound level shall follow the handset internal ring level. However, if the setting is “OFF” the alarm

sound level shall be “Level 1”. During generating the alarm sound, press any key to stop the alarm

without any operation even the handset is “Key Lock” mode. For example, press “KEY_HOOK” to

stop the alarm, however, the handset should not go to talk mode.

If do not press any key for more than one minute, the alarm shall stop automatically.

3.14.2 During Talk

26 of 40