User's Manual

If the call is unanswered and un-viewed. The and icon will stay ON. The
will be turned off after it is viewed.
If a matched number found in phonebook memory , the corresponding name will be
shown otherwise if the caller name is available, the caller name will be displayed. If
both are not available, the caller number is displayed on the 1
st
line.
Press KEY_OK, the first 12 digits of caller number is displayed
on the 1
st
line. If the
number is more than 12 digits, the first 12 digits are displayed with
icon. Press
KEY_OK to check the remaining digits with
icon.
5. When the CLIP found no matched number in Phone Book and Calling Number is present,
when press KEY_OK again , CLIP data can be stored into phone book ( see 3.7.7)
To select another call list, simply press KEY_UP/CLIP or KEY_DOWN/CLIP . Error tone will be
sounded if reach the top or bottom of the list.
To return to the previous menu, press KEY_MEM/EXIT.
To dial out number just simple press KEY_HOOK
3.7.5 Delete one CLIP list
• Press KEY_CLEAR and “Delete ?” appears.
• There you can either press KEY_OK and CLIP deleted, or presses
KEY_MEM/EXIT to cancel the delete operation.
3.7.6 Delete all CLIP list
• Long press KEY_CLEAR and “Delete All ?” appears.
• There you can either press KEY_OK and all CLID are deleted, or press
KEY_MEM/EXIT to cancel the delete all operation.
To return to the previous menu, press KEY_MEM/EXIT
3.7.7 Store a CLIP list into PHONEBOOK
• After appearing the “Add ?” and press KEY_OK to confirm ( after 3.7.4 step 5 )
• Press KEY_UP/CLIP or KEY_DOWN/CLIP to move the cursor for edit or delete
name. If the CLIP data does not have name, LCD shall display “Name ?”. And
then enter the name.
• Press KEY_OK after modified or enter the name.
• Press KEY_OK after modified number.
• Select the melody of your choice (1 to 5) and validate
• Press KEY_OK to confirm.
3.7.8 Dial out CLIP list
To recall the number from CLIP list, pressing KEY_HOOK will dial out the number.
3.7.9 KPN specification handling
3.7.9.1 DC/AC load activation
• When the unit detect the line reverse, the DC/AC load shall apply within 100mS -
200ms.
• When the unit detect line reverse, the unit need to wait next line reverse. If next
line reverse detect within 80ms, it define that the line reverse is due to ringer
signal.
• If the line reverse is due to ringer signal, the DC/AC load shall not apply
• During ringing stage, if detect ringer off for more than 80ms. The unit shall be
ready for detecting line reverse.
22 of 40