User's Manual

The earpiece volume will be displayed on the 1
st
line
as “Ear Vol n” (1<=n<=5) during 8 s unless a key
digit (KEY_0 to 9 + KEY_HASH + KEY_STAR) is pressed.
3.3 Direct access memory
The product has three locations of direct access memory dial number. The number can be re-
programmed by end user using handset menu (Hot keys). The maximum digits for each location are
16 digits and there is no name for this direct access dial number.
The following data shall be able to store to two direct access keys.
0 - 9, * , # , R , Pause
# If insert the “R”, it should have 1.5 seconds pause after the “R”.
EX: If store the “1234R78” to direct access keys. The dial shall be as follow
“1” + “2” + “3” + “4” + “Recall” + “1.5 second pause” + “7” + “8”
3.3.1 How to access the direct memory dial number during idle
User press and hold the KEY_1 or KEY_2 for more than 1.5 second (Long press), then the unit
display the pre-programmed number on the LCD. KEY_1 for location number 1 and KEY_2 for
location number 2. Then take the line and start to dial automatically.
3.3.2 During OFF HOOK
When the unit is on OFF HOOK mode, it is allowed to access direct access memory number anytime
when long press for KEY_1 or KEY_2.
3.3.3 Direct access dial data
The direct access keys dial data should not be stored to the Redial buffer. If use direct access keys
after dial some digits, only the digits before direct access keys dial will be stored to the redial buffer.
3.4 Redial feature
3.4.1 Limit for number of redial digits
There are two EEPROM setting data to define the maximum redial digit. Those two data must be lower
than 32 (20h). If more than 32, the reading data will be replaced by 32.
3.4.1.1 Selection for Redial data size
• The unit shall compare the two redial size data. If the data are same, there will be no redial
size selection menu.
• If the data are different, there will be Redial size selection menu. Then the user can select the
redial size by selecting the value. (Redial size selection menu --> see Menu setting)
• On the menu, the size data shall be come from EEPROM setting data.
3.4.1.2 Relation between redial list and redial size limit
• Redial list can keep up to 32 digits for each entries.
• When select the dialled number from the redial list and the number of digits is higher than
selected limit, the unit display only the digits up to size limit.
• When press KEY_TALK to start dialling, the unit dial out only up to limit. The rest of digit will
not be dial out.
3.4.2 Redial list
17 of 40