User's Manual

3.2.1 Dialling PAUSE
Press KEY_LNR (after first key) to make a pause, which is displayed as a "P".
The time is adjustable by FP EEPROM settings
3.2.2 Flash key
During a call, press shortly KEY_R to perform a Flash break and displayed as a “R”.
The flash time is adjustable by FP EEPROM settings
3.2.3 DTMF dialling
DTMF tone duration (pause before, tone length, pause after, high & low group level) is adjustable by
FP EEPROM settings
3.2.4 Pulse dialling
Pulse timing (make, break, pause after) is adjustable by FP EEPROM settings
Pulse dialling mode can be disabled by EEPROM settings.
(If disabled by setting, the dialling setting menu shall not be on the handset setting menu)
3.2.5 Temporary DTMF dialling
During a call or pre-dialling, when the selected dial mode is pulse and you want to dial DTMF codes,
During talk, press KEY_STAR/LOCK to switch into DTMF dialling, only during this call.
During pre-dialling or number storage, long press KEY_STAR/LOCK is used to program the digits
after the KEY_STAR going temporarily to DTMF dialling. This will be displayed “d”.
3.2.6 Dial tone detection
During an external outgoing call, the dial tone detection is activated. When detected the digits which
have been dialled on the handset (pre-dialled or post dialled) are sent to the line.
If the dial tone is not detected, a time out expires and the digits are sent.
The time out is adjustable by FP EEPROM settings
No dial tone detection time out: selected by EEPROM data.
With dial tone detection time out: selected by EEPROM data.
3.2.7 Call timer display
After going off hook, the display is blank during 15 s unless you press a key. The communication
duration is displayed after 15s after the last pressed key
on the 2
nd
line.
If you press a key (0 - 9) during the conversation, the communication duration is not reset to zero and
keep count up on the 2
nd
line.
At the end of each call, the duration of communication is displayed for 5
seconds
on the 2
nd
line.
The last 12 digits of dialled number is keeping display on the 1
st
line during the call.
3.2.8 Mute
It is possible to mute the microphone during a conversation.
Press KEY_CLEAR/KEY_MUTE during the conversation, the microphone is then deactivated, the
external correspondent is put on hold; you can talk freely without being heard by the calling party.
“MUTE” is displayed on the 1
st
line.
No digit key or KEY_INT can be used during mute.
Press KEY_CLEAR/KEY_MUTE again to return to normal mode. The 1
st
line then return to display
last 12 digits of dialled number.
The Phonebook can be reviewed, but it cannot be used for dialling.
Press KEY_CLEAR/KEY_MUTE again to return to normal mode.
3.2.9 Changing Earpiece Volume during Call
It is possible to change earpiece volume during a call using KEY_UP/CLIP and KEY_DOWN/CLIP.
16 of 40