User's Manual

3 Call User interface
3.1 Incoming call
The Phone should not ring when receiving a burst of notification. The network will send RPAS and
caller ID in short period of time (at 4 seconds interval)
Display
The display shows "Call" on the 1
st
line and EXT icon blinks (0.5 s ON/OFF), if caller ID information is
available (see 3.5), the caller name and number is displayed
. The caller name is on the 1
st
line and
number is on the 2
nd
line. (If the name is not available, only number is displayed on the 2
nd
line.)
If the received number is match with Phonebook entry, the entry name will be displayed
on the 1
st
line
instead of CID name data.
Both the Talk indication LED and key backlight shall be flashed during ringing. (0.25 s ON/OFF)
And both key backlight and LCD backlight shall be turned on.
Handset and base ringer melody and level as MENU setting.
Note 2: It is possible to change ring volume during the incoming alert by using KEY_UP/CLIP and
KEY_DOWN/CLIP keys.
The ring volume will be displayed as “Volume n” (1<=n<=3) or “Volume OFF” during 8 s unless
KEY_HOOK is pressed.
Incoming alert phase:
The incoming call phase begins with the first ring (ALERT_ON) signal of the handset and stops:
• If the user take the call (see operation)
• If the call is not answered and the caller release its call or another parallel phone answers.
EXT icon and LEDs will stop flashing after FTXX_LINE_EXPIRY.
The Base ring alert is synchronized with the PSTN ring ON/OFF pattern.
RPAS disable:
If the first ring period is less than the RPAS length value which is define by EEPROM, the unit shall not
emit the ring alert sound.
It is possible to be enabled by base setting menu. And the default setting shall be defined by EEPROM
setting.
3.1.1 To answer the call:
 Press
KEY_HOOK.
 Simply lift the handset from the cradle.
HOOK_IND icon will be displayed.
Note 1: After it goes to talk mode automatically, KEY_HOOK will be disabled about 3 seconds to
prevent unwanted hang up.
Note 2: Once handset TALK on, another handset’s display “EXT” icon and can not TALK &
TONE_BUSY in earpiece if press KEY_HOOK
3.2 External outgoing call
Normal dialling :
• Press KEY_HOOK
• Enter the called number
Pre-dialling:
Pre-dialling allows you to enter and modify a number before dialling.
• Dial your called number. Up to 32 digits (included pause, *,#)are allowed. If the number
exceeds 12 digits,
then move to 2
nd
line.
If more than 24 digits, the last 24 digits are displayed
and LEFT_ARROW is ON, Press KEY_CLEAR key to delete last digit.
• Press KEY_HOOK, the digits are dialled, digit(s)
15 of 40