User's Manual

• If the item does not exist on the list, then the de-notification which has number will be ignored.
However, if the
icon is flashing and received de-notification does not have number, and
there is no notification on the list, the
icon will be removed.
• When remove the notification and after remove the notification, if no other notifications are remain
in the list, the
icon will be removed.
• When receive the VMWI notification without server number, the icon shall start to flash.
However, the notification shall not be stored to the call list.
• When receive the VMWI de-notification without server number, the
icon will be removed if
no notifications are in the list.
• Any kind of de-notification shall not be stored to call list.
• The user can manually turn off the display of
icon, by a long press of “5”, whilst viewing CID
list. (It will effect to other handset and base also delete all the notification on the list)
• The user can manually remove VMWI notification from the CID list using delete function. When
removed the notification and the notification was last one, the
icon will be removed. (It will
not effect to other handset and base)
Note:
• The VMWI data “0Bh + FFh or 00h” shall be received regardless Data link message such as “80h
or 82h”.
2.10 Redial list mode
Refer to redial features
2.11 CLIP mode
Refer to Caller ID (CLIP) feature
2.12 Charging mode
Refer to Charging conditions
2.13 Busy mode
When one Handset is TALK, another handset’s “EXT” icon, and TONE_BUSY in earpiece if press
KEY_HOOK
2.14 Power down
Make a long press on KEY_R/POWER, and the handset power down.
Press and hold KEY_R/POWER for 5 seconds to wake it up. When the handset wakes up, the clock
time data shall be transferred from base.
This function can be enable or disabled by EEPROM setting
14 of 40