User's Manual

- The VMWI signal may be contained Type 2 CID data. So, during Talk mode and received the
(Parameter type 0Bh + Data FFh), the information will be kept and once the unit goes to standby,
then the IN-USE LED starts to flash.
1.4.3 Tones
The three base melodies are shown in the following table
Nr Name
1
Ring 1
2
Ring 2
3
Ring 3
4
Ring 4
5
Ring 5
6
TONE_CONFIRM
2 Main User interface
2.1 Power up
Plug the power supply into the base. The in use LED will be turned on and TONE_CONFIRM.
Insert batteries in the handset. If battery level is enough (see Start up with low batteries chapter), the
handset will start.
The display will show “Base 1” and antenna flashing, until it locks onto its subscribed base. If the
handset finds its base in the first 10 seconds, no beeps are played (see Range indication chapter).
Then the display shows the standby display.
2.2 Standby mode
In standby mode, the display shows the handset name and the handset number.
The ANTENNA icon is steady. The BATTERY icon indicates the charge level.
Handset:
Events Handset mode
Press KEY_HOOK Enter TALK mode
Press KEY_INT Enter intercom mode
Press KEY_MENU Enter MENU mode
Press KEY_MEM Enter phonebook mode
Press KEY_HASH /LOCK
(hold 3 second)
Enter KEY LOCK mode
Press KEY_LNR/PAUSE Enter redial list mode
Press KEY_UP/CLIP or
KEY_DOWN/CLIP
Enter CLIP mode
Press KEY_R/POWER
(hold 3 second)
Enter power down mode
Press 1,2,3……0,*,# Pre-dialling
Incoming call signal Incoming call mode
Another handset TALK Busy mode
Battery is low Battery low icon
Battery is too low Power down mode
On charging Charging mode
12 of 40