User's Manual

10
Ring 10
6
TONE_CONFIRM
7
8
9
TONE_LOW_BATT
10
TONE_FREE
11
TONE_CALL_WAITING
12
TONE_BUSY
13
TONE_ERROR
14
TONE_IN_RANGE
15
TONE_WARNING
16
TONE_OFF_HOOK_WARNING
17
TONE_RING_BACK
18
TONE_ALARM_CLOCK
1.4 Base description
1.4.1 Page Key
Key action MMI action
Short press (<5 s) Send a page to handsets
Long Press (>=5s) Enters subscription mode (in use LED will flash)
1.4.2 LED
 Power/In use LED
Action LED state
Standby mode ON
Subscription mode Flash
In call Flash
Incoming call Flash synchronized with PSTN ring pattern.
New SMS message Flash (Not for DECT 6.0)
### Add the EEPROM setting (FP) to enable the VMWI indication on the base unit.
Especially for Australia, it is better to have VMWI on the base unit. It should enable or disable this
function by EEPROM setting.
(If there is not only one Voice mail server, this function shall be disabled by EEPROM setting)
Operation:
- Receive the CID data (Parameter type 0Bh + Data FFh), and then activate the base IN-USE LED
to be flash.
- The Flashing rate is 0.2S - 0.25S ON/OFF
- This Flashing is lower priority, so, any other operation to turn ON the IN-USE LED, those
operation have priority.
- The Flashing is keeping until received the CID data (Parameter type 0Bh + Data 00h) regardless
the unit goes to oh-hook or off-hook.
11 of 40