User's Manual

4.3.10.1 Quick KEY LOCK
Simply press and hold KEY_STAR/LOCK 3 second
4.3.10.2 To unlock key:
• Press any key “PRESS ＊” is displayed, within
5s time out
• Press KEY_STAR/LOCK to unlock key
4.4 REGISTER
• Select "REGISTER" and validate
• Select “SELECT BASE” or “REG BASE” by KEY_UP or KEY_DOWN
• Press KEY_OK to confirm
4.4.1 SELECT BASE
• Select "SELECT BASE" and validate
• “BASE 1 2 3 4” is displayed ( only the registered base number will be shown and current
base number will be blinking)
• Press 1 - 4 to confirm the selection or KEY_UP/KEY_DOWN + KEY_F to select auto
searching.
• Valid tone is sounded if valid base is found
• “NOT REGISTER” is shown and error tone sounded the selection is invalid
4.4.2 REG BASE
• Select "REG BASE" and validate
• “BASE 1 2 3 4” is displayed ( only the registered base number will be blinking )
• Press 1 - 4 to confirm the selection
• It is now searching the base in subscription mode and “SEARCHING…” is displayed
• Valid tone is sounded and “PIN ?” is shown if valid base found
• Enter subscription PIN code and verified by base
• Valid tone sounded if subscription is successful and back to standby mode.
On the base:
• Put the base into subscription mode, by pressing and holding PAGE_KEY
• The base will then emit a beep, the Line LED will flash. It is now ready to be associated with a
new handset, during the 90 seconds after pressing the button only.
If the handset has located the base, a valid tone is played.
If the handset does not locate the base, it will return to the previous configuration after 1 minute. Try
again by changing the base number and check that you are not in a environment where there is
interference
When a handset is associated with a base, it is given a handset number by the base. It is this number
which is displayed on the handset after the name and must be used for internal calls.
5 Prefix dialling
There are two data for prefix dialing. One is Detect string and other is Replace string. If user enter the
number and first sevelrale string match with the pre-programmed string data, then the string will be
replaced by pre-programmed Replace string data. This function can be enabled or desabled by
EEPROM setting.
22 of 25