User's Manual
Table Of Contents
- USER_MENU.pdf
- USER_MENU.pdf
- Handset description
- Base description
- Main User interface
- Call User interface
- MENU Settings
- Prefix dialling
- Quick default settings
- Subscribe a new handset
- Test modes
- Specifications
- USER_MENU.pdf
Note 1: After it goes to talk mode automatically,
KEY_HOOK
will be disabled about 3 seconds to
prevent unwanted hang up.
Note 2: Once handset TALK on, another handset’s display “EXT” icon and can not TALK &
TONE_BUSY in earpiece if press KEY_HOOK
3.2 External outgoing call
Normal dialling :
• Press KEY_HOOK
• Enter the called number
Pre-dialling:
Pre-dialling allows you to enter and modify a number before dialling.
• Dial your called number. Up to 32 digits (included pause, *,#)are allowed. If the number
exceeds 12 digits, the last 12 digits are displayed and LEFT_ARROW is ON, Press
KEY_CLEAR key to delete last digit.
• Press
KEY_HOOK
, the digits are dialled, digit(s)
3.2.1 Dialling PAUSE
Press KEY_LNR (after first key) to make a pause, which is displayed as a "P".
The time is adjustable by FP EEPROM settings
3.2.2 Flash key
During a call, press shortly KEY_R to perform a Flash break and displayed as a “R”.
The flash time is adjustable by FP EEPROM settings
3.2.3 DTMF dialling
DTMF tone duration (pause before, tone length, pause after, high & low group level) is adjustable by
FP EEPROM settings
3.2.4 Pulse dialling
Pulse timing (make, break, pause after) is adjustable by FP EEPROM settings
Pulse dialling mode can be disabled by EEPROM settings.
(If disabled by setting, the dialling setting menu shall not be on the handset setting menu)
3.2.5 Temporary DTMF dialling
During a call or pre-dialling, when the selected dial mode is pulse and you want to dial DTMF codes,
During talk,
long press KEY_STAR/LOCK to switch into DTMF dialling, only during this call.
During pre-dialling or number storage, long press KEY_STAR/LOCK is used to program the digits
after the KEY_STAR going temporarily to DTMF dialling. This will be displayed as a “d”.
3.2.6 Dial tone detection
During an external outgoing call, the dial tone detection is activated. When detected the digits which
have been dialled on the handset (pre-dialled or post dialled) are sent to the line.
If the dial tone is not detected, a time out expires and the digits are sent.
The time out is adjustable by FP EEPROM settings
No dial tone detection time out : selected by EEPROM data
with dial tone detection time out : selected by EEPROM data
3.2.7 Call timer display
After going off hook, the display is blank during 15 s unless you press a key. The communication
duration is displayed after 15s after the last pressed key
7 of 25