User's Manual
Table Of Contents
- USER_MENU.pdf
- USER_MENU.pdf
- Handset description
- Base description
- Main User interface
- Call User interface
- MENU Settings
- Prefix dialling
- Quick default settings
- Subscribe a new handset
- Test modes
- Specifications
- USER_MENU.pdf
2.1 Power up
Plug the power supply into the base. The in use LED will power on and
TONE_CONFIRM.
Insert batteries in the handset. If battery level is enough (see Start up with low batteries chapter), the
handset will start.
The display will show “BASE 1” and antenna flashing, until it locks onto its subscribed base. If the
handset finds its base in the first 10 seconds, no beeps are played (see Range indication chapter).
Then the display shows the standby display.
2.2 Standby mode
In standby mode, the display shows the current time and the handset number, preceded by HS.
The ANTENNA icon is steady. The BATTERY icon indicates the charge level.
Handset:
Events Handset mode
Press KEY_HOOK
Enter TALK mode
Press KEY_INT
Enter intercom mode
Press KEY_MENU
Enter MENU mode
Press KEY_MEM
Enter phonebook mode
Press KEY_STAR/LOCK
(hold 3 second)
Enter KEY LOCK mode
Press KEY_LNR/PAUSE
Enter redial list mode
Press KEY_UP/CLIP or
KEY_DOWN/CLIP
Enter CLIP mode
Press KEY_R/POWER
(hold 3 second)
Enter power down mode
Press 1,2,3……0,*,#
Pre-dialling
Incoming call signal Incoming call mode
Another handset TALK Busy mode
Battery is low Battery low icon
Battery is too low Power down mode
On charging Charging mode
Long press for 1 or 2
Access direct pre-programmed
number
Base:
Events Base mode
Press PAGE KEY
Enter PAGE mode
Incoming call signal Incoming call mode
2.3 TALK mode
Refer to External outgoing call
2.4 Intercom mode
Refer to intercom
2.5 Incoming call mode
Refer to incoming call
5 of 25