User's Manual

WELCOME MODE
G13
G14
Sélect. Retour
UK (BT)
UK (Abc)
Pays
France
G15
Réinit. terminée
Pays
Menu Noms
Combiné 1
G16
KEY_SOFT_1
1. A welcome mode is presented when a product is powered on for the first time and after a factory reset.
A welcome mode enables automatic configuration of the line interface, CLI, SMS and TAM parameters stored in EEPROM / flash when
the user selects their country of origin and operator.
This feature can be hidden in EEPROM.
2. A welcome screen (see screen G13) is presented for 5 seconds before user is asked to select a country (operator).
3. On the select Country screen (see screen G14) as user scrolls through the country listing the menu title changes to the country
native language.
4. If Back (KEY_SOFT_2) is pressed any time during country selection - the handset will return to the welcome screen (screen G13).
5. Once a country (operator) is selected. Both the handset and base will reset to enable correct settings. Further screens will be
presented in that country default language setting.
6. The end user has the possibility to change the display language in the handset menu without affecting the country settings.
7. User can make and receive calls withour first selecting the country and operator. However, the Welcome screen will re appear until
the phone has been configured with a country setting.
8. The timing of the Welcome screen re appearing when it is not set can be defined in EERPOM.
9. Once welcome mode is set on one handset - registering additional handset will not prompt the welcome screen. Once registered,
additional handset will communicate with the base to ensure correct settings is applied.
10 . If the language is changed after the Welcome mode has been set and another handset is registered - the handset language is not
changed but will take the default language set for the country selected.