Instruction Manual

36 37
Click
Installation and start-up
2
Placing the sunshade down
Carefully place the sunshade on
a clean, horizontal surface. The
sunshade is very heavy. Work in a
threesome and hold the sunshade
securely.
!
Caution: Ensure that the ratchet
pins have clicked into place!
!
1. Fasten the lower pole into the top
pole
2. Click ratchet pins into place
Put the sunshade together
3
Suitable floor mounts are available
from your SUNCOMFORT/GLATZ
dealer.
i
Set up base on even and stable
surface.
Place sunshade in base
5
1. Place sunshade in base
2. Tighten the base tube clamp
3. Insert cable
Prepare the floor fastening
Floor fastening weights and wind
resistance
Size minimum weight
[cm] [kg]
40 x 40 x 4 120
1. Mount cross base
2. Place the base plate and fix it with 4
countersunk screws
3. Place stand pipe on cross base
4. Adjust holes / position
5. Place 4 washers in position
6.
Pre-assemble standpipe with
4 round-headed screws (M10 × 20mm)
7. Weigh down the cross base with
weights
4
40 x 40 x 4 180 (400 x 400)
(350 x 350)
Supplied with:
- Upper pole with sunshade canopy
- Lower pole
- Operating instructions
Optional:
- Cross base with stand pipe, mounting
material, protective cover
Unpacking the sunshade
1
Dispose of packaging material proper-
ly and keep away from children.
Do not make use of defective material.
In the event of any damage, inform the
transport service provider immediately.
!
4×
4×
4.2
4.3 … 4.6
4.1
5.1
5.3
5.2