Owner's Manual
Table Of Contents
- Preface
- Theory of Operation
- Specifications:
- Component Description
- Maintenance / Cleaning
- Returns
- Disposal Instructions
- Troubleshooting
- Sieve Bed Assembly Replacement (505849):
- Control Panel Replacement (507646):
- PC Board Replacement (506729/506729S O2 Sensor Models):
- Oxygen Sensor Replacement (508419) Models with O2 Sensor
- Internal Battery Replacement (507547):
- Compressor Plate Assy Replacement (506320):
- Checking the Oxygen Purity
14 | P a g e
17.1. Install a Cable Tie through the right side mounting hole of the Oxygen Sensor PC Board and around
the Battery Connector wires, closest to the Battery Plug. Snug and trim Cable Tie.
17.2. Install a Cable Tie around the bundle of tubing to the right side of the welded filter. Snug and trim
Cable Tie. NOTE: Do NOT over tighten Cable Tie. Will crimp tubing if too tight.
18. Be sure the wires from the Pump are pushed down and into their original position.
19. Stand the POC up.
20. Follow steps 2 thru 12 of the “Reassembly” section of the “Sieve Bed Replacement” in this manual.