Use and Care Manual

27
-i`ÊÃÃiLÞÉi>`iÀÃÊVÌÕi`®
1
1
3
2
V
40
LL
V
x6x6
-iVÕÀiÊÀi>ÀÊi>`iÀÊÜÌÊi>`iÀÊLi>Ê6®Ê>`Ê>ÌÌ>VÊ
with six screws (LL).
Note: Header beam (V) has large holes on one side and
small holes on other side. The small holes must face
header.
1
1
3
2
41
x2
LL
x8x8
-`iÊÌÀÕÃÃÊ>ÃÃiLÞÊÌÊ«>Vi°Ê-iVÕÀiÊÌÊÃ`iÊ«>iÃÊ
with four screws (LL) in each side adapter bracket.
1
3
2
42
HH
FF
T
Raise ridge beam (T) up and into rear roof ridge beam
LÀ>ViÌ°Ê-iVÕÀiÊÜÌÊiÊÓ¸ÊiÝÊLÌÊ®Ê>`ÊiÊÕÌÊ®°
Note: Alignment of ridge beam to bracket may require
header panels to be pushed inwards or outwards slightly
as ridge beam is slid into place.
1
3
2
43
HH
T
FF
-`iÊÀ`}iÊLi>Ê/®ÊÌÊvÀÌÊÀvÊÀ`}iÊLi>ÊLÀ>ViÌ°Ê
-iVÕÀiÊÜÌÊiÊÓ¸ÊiÝÊLÌÊ®Ê>`ÊiÊÕÌÊ®°
Note: Alignment of ridge beam to bracket may require
header panels to be pushed inwards or outwards slightly
as ridge beam is slid into place.