Instructions / Assembly
1
2
F
18
Align tabs on bottom right side of left back corner (F)
with slots along rear floor. Lower panel into slots and
lock in place by sliding panel toward corner.
Note: Use a rubber mallet to “push” left back
corner (F) into locked position.
-i`ÊÃÃiLÞÉ7>ÃÊVÌÕi`®
1
22
19
F
Tip left back corner (F) outward slightly and bend corner
hinge.
3
4
F
20
Tip left back corner (F) back to vertical position and align
lower tabs on left side with slots in floor. Left back corner
should align and overlap previously installed side panel.
Top viewTop view
F
Side viewSide view
Before proceeding, make sure
corner is square (top view) where it
meets the floor and that panel is flush
(side view) with floor.
If not, repeat Steps 18–20
until square and flush.
21