Instructions / Assembly

12
1
3
2
x8
LL
5
K
U
-`iÊÀvÊÀ`}iÊLi>ÊLÀ>ViÌÊ-®ÊÕ`iÀÊÌ>LÃÊÊÃ`iÊ
peak of front header (K) and secure with two screws
(MM). DO NOT over tighten screws.
Repeat for rear header (L).
Lay front header (K) on ground with lettering facing up.
Place vent screen (U) into rear opening in front header (K).
-iVÕÀiÊÌÀÕ}ÊL>VÊvÊi>`iÀÊÜÌÊi}ÌÊÃVÀiÜÃÊ®°Ê
DO NOT over tighten screws.
Repeat for rear header (L).
1
2
4
x2
K
MM
S
i>`iÀÊ*ÀiÃÃiLÞ
Parts/hardware needed for header pre-assembly are shown on pages 6 and 8.